· While in Furcadia, click on the ‘C’ tab in the lower left hand corner of your screen.

· Click on the button that says ‘Edit My Settings’.

· Scroll through the configuration tabs until you see ‘Ignores’.

· Select the ‘Ignores’ tab.

· Check the ‘Save ignored names’ box.

Enter the furre’s name in the ‘Add Player’ line, and hit the ‘Add’ button.

Make sure to hit the ‘Save button’.

>From now on, anytime you ignore a player, it will remember your ignore and you'll still be ignoring them the next time you log into Furcadia.

You can also enter names to ignore directly in your furcadia window by typing:

ignore furrename OR ignore Furre|Name

(the | is used in place of a blank space if the name has more than one word in it)

OR!:

Locate your Furcadia directory; for most, it will be located in C:Files.

In your Furcadia directory, you will need to find a file entitled ‘settings.ini’ and open it.

Scroll down to the end of the file, and you will find a section about the use of the ignore tagline.

At the very end of the document, where ‘[ignores]’ is written, do the following:

On the line directly under ‘[ignores]’, type the name of the furre you wish to ignore.

If there are more than one furres that you wish to ignore, make sure that each one is on a separate line. It should look something like this:

[Ignores]

Joe|Furre

BillyJoe

Jennifurre

When you are finished writing the names of those you wish to ignore, be sure to save the file. You can do this by selecting ‘File’ and then scrolling down to ‘Save’. Exit out of the file. Note that this does not take effect until you restart Furcadia, so you may wish to use the `ignore <furrename> command in the meantime.